QMobile Not Filling Charging in Mobile - Qmobile Solutions

Video on how to solve charing problem in QMobile.

QMobile which is indicating charging but not filling charging in the phone. That is not a big deal, may be near charging jack your diode got broken or the connection which gives voltage to circuit broke the connection, why this happen written below. Learn how to solve QMobile Charging not filling in Qmobile Handset.

Early Steps to Solve QMobile not Charging:

• Turn off your Mobile and Open it using screw driver.
• Carefully take out your circuit.
• Connect your Charger usually of 5v output.



QMobile Charging Problem

• 
  

Repairing Steps of QMobile Charging Problem:

1. Set your multi-meter to 10 volt.
   setting to 10v we get every single current signal under 10v.
2. Connect Positive (+) wire of multi-meter to circuit on charging jack.
3. Similarly Negative (-) of multi-meter with negative on charging jack.
4. You will get low voltage on these probably 3v.
5. You will notice a single jumper or diode could be broken or damage.
6. We don't know which diode is attached to there before.
7. To get complete 5v we make the connection direct.
8.  Using solder iron we will merge the both point.
9. check using multi-meter so we get required 5v on multi-meter.
10. After that connection we get charge filling result.

Why Problem Happen?

The phone could be fall  from height or you get punch on it. By falling the jumpers got loose and in a result we get connection cut via diode.

Be careful with the phones the diode got damaged by falling. May be your phone got heated near charging jack because the charging not filling itself.